Peptide Initiative

Injection guide · Growth Hormone

How to inject CJC-1295 (No DAC)

A modified growth hormone-releasing hormone that boosts your body's natural GH pulses for better recovery, deeper sleep, and improved body composition .

SubcutaneousRoute
3 recommendedSites
Once dailyFrequency

01 · Preparation

What you'll need

  • Bacteriostatic water (BAC water)
  • Insulin syringe (29-31 gauge)
  • Alcohol swabs
  • Sterile vial of CJC-1295 powder

Pro tip

Prepare all supplies on a clean surface before you begin. Having everything ready makes the process smoother and more sterile.

02 · Mixing

Reconstitution steps

  1. Wash your hands thoroughly with soap and water. Gather all supplies on a clean, flat surface.
  2. Remove the plastic cap from the peptide vial and wipe the rubber stopper with an alcohol swab. Let it air dry.
  3. Draw the appropriate amount of bacteriostatic water into a sterile syringe.
  4. Insert the needle into the vial at an angle, aiming at the inside wall of the vial. Slowly push the plunger to let the water trickle down the glass wall -- do NOT squirt directly onto the powder.
  5. Once all water is added, gently swirl the vial in a slow circular motion. Never shake the vial, as this can damage the peptide bonds.
  6. Continue swirling until the powder is completely dissolved and the solution is clear. If particles remain, let the vial sit for a few minutes and swirl again.
  7. Label the vial with the date of reconstitution, the peptide name, and the concentration (e.g. 250mcg per 0.1mL).

Example calculation

2mg vial + 2mL BAC water = 1mg/mL (1000mcg/mL). This means each 0.1mL contains 100mcg.

Dose calculation

For 100mcg dose at 1mg/mL concentration: draw 0.1mL (10 units on insulin syringe)

Pro tip

Always add the bacteriostatic water slowly, letting it run down the side of the vial. Never shake the vial -- swirl gently to avoid damaging the peptide.

03 · Location

Choosing your injection site

  • Site 01AbdomenPinch the skin 2 inches from navel. Avoid the area directly around the belly button. Rotate between left and right sides.
  • Site 02AbdomenPinch the skin 2 inches from navel. Avoid the area directly around the belly button. Rotate between left and right sides.
  • Site 03Outer ThighMiddle third of the outer thigh. Keep at least 4 inches above the knee and below the hip. Alternate legs each injection.

Rotate between 3 sites to prevent tissue buildup and ensure consistent absorption.

Pro tip

Rotate your injection sites with each dose to prevent lipohypertrophy (buildup of fatty tissue). Keep a simple log of where you last injected.

04 · Step by step

Injection technique

  1. Clean injection site with alcohol swab and let dry
  2. Pinch a fold of skin between thumb and forefinger
  3. Insert needle at 45-90 degree angle into pinched skin
  4. Inject solution slowly
  5. Remove needle and apply light pressure (do not rub)

Pro tip

This peptide uses subcutaneous injection into fatty tissue. Inject at a 45-90 degree angle into pinched skin. Aspirate before injecting to ensure you haven't hit a blood vessel.

05 · Timing

Your schedule

How often

Once daily

Best time

Before bed on empty stomach (most popular), or morning fasted and pre-workout

Dose levels, food and stacking notes and a sample day are on the CJC-1295 (No DAC) dosing protocol.

06 · Preservation

Proper storage

Before mixing

Store lyophilized (freeze-dried) powder in freezer at -20C for long-term storage (years) or refrigerator at 2-8C for up to 12 months. Keep in original vial away from light and moisture.

After mixing

Refrigerate immediately at 36-46F (2-8C). Never freeze reconstituted peptide. Keep vial upright and away from light. Use within 21-28 days.

Shelf life after mixing

21-28 days

Signs of degradation

Discard the vial immediately if you notice any of these:

  • Cloudy or hazy solution (should be crystal clear)
  • Visible particles or floating matter
  • Solution that has been left at room temperature for extended periods
  • Any discoloration from the original clear appearance

07 · Important

Safety reminders

When to stop

  • Signs of allergic reaction (hives, swelling, difficulty breathing)
  • Persistent severe headaches that don't improve
  • Significant joint pain or carpal tunnel symptoms
  • Development of diabetes symptoms (excessive thirst, frequent urination)
  • Any concerning changes in moles or skin growths
  • Planned surgery (stop 1-2 weeks before)

Always consult with a healthcare provider before starting or stopping peptide therapy. This information is for educational purposes and does not replace medical advice.

Clean technique checklist

  • Wash hands thoroughly with soap and water before handling supplies
  • Swab vial tops and injection site with alcohol and let dry
  • Never touch the needle tip or allow it to contact non-sterile surfaces
  • Use a new syringe and needle for each injection
  • Dispose of used sharps in a proper sharps container
  • Store reconstituted peptides according to the storage instructions above

Continue

This guide is for informational purposes only and is not medical advice. Always consult with a qualified healthcare provider before starting any peptide protocol. Individual responses may vary.